Our Jump rings are anodized before they are cut so the ends are raw aluminum however with the coating thickness we use and with the thin blades we cut our Jump rings with, if you close the rings properly the seam can not be seen.
Our Anodized Aluminum Jump rings are anodized in house at our sister company, Premier Anodizing & Metal Finishing. This assures that we will never be out of stock of a color and that we have control over our quality. However, the colors can change slightly from batch to batch. We use a spectrometer to get the closest color matches possible but there still can be some differences, this is normal in the anodizing process. Therefore, you should order enough jump rings to finish your project all at the same time. FDA Approved - The anodizing process we use is FDA approved for cookware. Premier Anodizing uses only organic dyes and is rated non-hazardous.
Jump Ring Weight - Anodized Aluminum Jump rings are lighter weight than Enameled Copper Jump rings. The coating is fairly hard but it can be scratched with steel.
Anodized Aluminum Jump Rings - Specifications
Our jump rings follow the American Wire Gauge (AWG), also known as Brown and Sharpe (B&S). All sizes listed are inside diameter (I.D.), which corresponds to the size of the mandrel onto which the wire is wound. Use these I.D.'s as a guide not an absolute as springback can occur.
|AWG Wire Measurements|
|Size||Inches (Imperial)||Millimeter (Metric)|
|20awg (Other Metals)||.032"||.8mm|
Anodized Aluminum Jump Rings - Approximate Jump Rings Per Ounce Chart